Assembling truck bed

                                                                                                                        Bed fully assembled 

Front clip in place

                                                                                                                       Bed installed on chassis

Partial engine wiring

                                                                                                        Rear fender installed with welt  

Truck rear completed

                                                                                                                      Truck looking good  

Trial fit front fenders and running board

                                                                                                              Wiring under seat started

Stainless trim added to grille

                                                                                                                          Original VIN tag

Strokers of St. Louis back in business

                                                                                        Cowl lights wired for Park and turn signals

Insulating firewall to reduce engine heat and noise

                                                                                                                  Truck beds completed 

Truck beds completed

                                                                                  Tilt steering column and gage cluster installed  

Hushmat silencer pads to reduce heat and engine noise

                                                                                                   Electronic gage cluster hooked up

Entire truck cab insulated from heat and noise by Hushmat pads installed over Lizardskin spray-in deadner